Consentric bearing on 21R\ w58 gearbox to 1600 Kent

Moderator: BradW

Consentric bearing on 21R\ w58 gearbox to 1600 Kent

Postby 200sxrb25 on Thu May 25, 2017 12:49 pm

Made this spacer made up.

Image
Image
You cut the sleeve of just in front of the oil seal.
Image
Image
Last edited by 200sxrb25 on Thu May 25, 2017 12:59 pm, edited 1 time in total.
200sxrb25
 
Posts: 64
Joined: Thu Jul 21, 2011 12:17 am

Re: Consentric bearing on 21R\ w58 gearbox to 1600 Kent

Postby 200sxrb25 on Thu May 25, 2017 12:50 pm

Image
Image
Image
200sxrb25
 
Posts: 64
Joined: Thu Jul 21, 2011 12:17 am

Re: Consentric bearing on 21R\ w58 gearbox to 1600 Kent

Postby 200sxrb25 on Thu May 25, 2017 12:52 pm

Image
Image
Image
The concentric is of a Ford Ranger 3.2
200sxrb25
 
Posts: 64
Joined: Thu Jul 21, 2011 12:17 am

Re: Consentric bearing on 21R\ w58 gearbox to 1600 Kent

Postby 200sxrb25 on Thu May 25, 2017 12:55 pm

Image
Image
Image
Image
200sxrb25
 
Posts: 64
Joined: Thu Jul 21, 2011 12:17 am

Re: Consentric bearing on 21R\ w58 gearbox to 1600 Kent

Postby 200sxrb25 on Thu May 25, 2017 12:58 pm

Got 17mm travel on it
Image
Image
Image
Used a sold rond bar to line it up
Image
200sxrb25
 
Posts: 64
Joined: Thu Jul 21, 2011 12:17 am

Re: Consentric bearing on 21R\ w58 gearbox to 1600 Kent

Postby BradW on Thu May 25, 2017 1:06 pm

Good Job, you actually only need about 6-7 mm movement to clear the clutch.

Piece of advice from experience put a pedal stop on the clutch pedal, and set it only when the engine is running etc, so it stops the pedal travelling any further than when the clutch is clear, if it is allowed to push too far it will 'pop' the slave cylinder piston out of the cylinder.

Also be careful bleeding don't pump like you would brakes, again chance of popping the cylinder, best way to bleed is put a long pipe on the bleed nipple and suck any air out, just watch the fluid coming up the pipe it doesn't taste nice :-).

Brad
User avatar
BradW
Site Admin
 
Posts: 868
Joined: Sat Jul 31, 2004 5:28 pm
Location: Johannesburg, South Africa

Re: Consentric bearing on 21R\ w58 gearbox to 1600 Kent

Postby 200sxrb25 on Mon Jun 19, 2017 9:10 am

Report back... The consentric work 100%... still to do sum fine tuning but works great.
200sxrb25
 
Posts: 64
Joined: Thu Jul 21, 2011 12:17 am


Return to Birkin

Who is online

Users browsing this forum: No registered users and 1 guest

cron